Adapt Hook Extenders

Adapt Hook Extenders (sold as a pair) add height to Adapt Hooks to increase the holding capability of our stands under special circumstances.  They can be installed onto the tips of Adapt Hooks in either of 2 orientations for two different amounts of height increase.  Use them in either of the following situations. 

• If the bottom front face of gear is angled or highly curved it's possible that gear could slip on an angled stand.  This applies to:  Modal keyboards, Korg minilogue xd keyboard, Roland RC-202, RC-505, TR-626, Jupiter Xm, early Roland Aira synths (TR-8, MX-1, TB-3, VT-3), microKorg.  NOTE:  The TR-8S has a square front face and does NOT need Adapt Hook Extenders.
• People living in earthquake-prone areas might want to consider adding Hook Extenders for all gear on all SynthRISE stands.

INSTALLATION: Slide the Hook Extender over the small rubber tab on an Adapt Hook.  Push down until the tiny post on the grey side plate drops into place in the tiny socket well on the Adapt Hook.  These subtle details will firmly lock the Hook Extender into place once the Adapt Hook is secured to the side panel of a stand.

NOTE:  These Adapt Hook Extenders fit our old Adapt Wings OG perfectly.

See our Adapt System page for more details.

Produced only by SynthRISE (previously known as KVgear).